Drain-tile suction
Drain-tile suction draws radon out through existing perforated drain tile: $900–$1,800 installed (HomeGuide, 2026), a 50 to 99% reduction in EPA's table.
- $1,200–$2,000 typical installed system (HomeGuide)
- 4 pCi/L is EPA's action level
- 1 in 15 US homes estimated elevated (EPA)
- Free quotes from certified or licensed mitigators
Fast response from independent local providers. No obligation.
Typical national cost$1,200 – $2,000Cost guide →About Drain-tile suction
If the house already has perforated drain tile around or under the footing, the contractor can draw suction on that loop instead of drilling a new point through the slab. EPA says drain-tile suction works with either a partial or complete loop, and its cost table credits it with the same 50 to 99 percent reduction as sub-slab suction.
HomeGuide's February 2026 survey prices drain-tile suction at $900 to $1,800, slightly below a standard sub-slab system. EPA's 2010 table gave $800 to $1,700 installed and $50 to $200 a year to run, in 2010 dollars, the lowest yearly cost among the fan systems along with sub-slab suction.
Common Jobs We Route
- Suction on perforated drain tile that runs around the footing
- Suction on drain tile under the footing
- Suction on a partial loop, which EPA says also works
- Sump-hole suction where the tile drains to a sump: an airtight lid lets it keep draining water ($900–$2,500 for sump sealing, HomeGuide)
- Post-mitigation test: $125–$400 professional or $10–$30 for a kit (HomeGuide)
What Affects the Price
Providers quote their own work — these are the factors that consistently move the number.
- Installed range: $900–$1,800 (HomeGuide, Feb 2026); EPA's 2010 table $800–$1,700 (2010 dollars)
- Pipe route: an exterior wall versus through the attic (interior or attic route est. ×1.15 in our calculator)
- Extra suction points, est. $250–$500 each
- Permit $25–$150 where required (HomeGuide)
- Running cost: $50–$200 a year (EPA, 2010 dollars)
How It Works
- Step 1
Confirm the result
EPA's rule for fixing is a long-term result of 4 pCi/L or more, or the average of two short-term tests at that level.
- Step 2
Ask which suction point and why
A good bid names the suction point, the fan location, the pipe route and any diagnostic tests, so you can tell whether drain-tile suction suits your house.
- Step 3
Retest after installation
EPA recommends a post-mitigation test within 30 days but no sooner than 24 hours after the fan starts.
Cost Guides
Drain-tile suction FAQs
How much does drain-tile suction cost?
HomeGuide puts it at $900 to $1,800 (Feb 2026), slightly below a standard sub-slab system. EPA's 2010 table gave $800 to $1,700 in 2010 dollars.
Does the drain tile have to go all the way around the house?
No. EPA says drain-tile suction works with either a partial or complete loop.
What does it cost to run?
EPA's 2010 table lists $50 to $200 a year for drain-tile suction, the same as sub-slab suction (2010 dollars).
Drain-tile suction by Area
Need drain-tile suction?
Send the short form — no obligation.